采用温控和碘吸收池技术的发射激光稳频技术

多普勒测风激光雷达通过分析系统回波信号的多普勒频移反演出风速，为提高风场探测精度，从稳频技术方面展开研究。在稳频过程中，分别采取措施消除激光频率的长期漂移和短期抖动。针对激光频率的长期漂移，设计并研制了种子激光器温控箱，通过水浴的控温方式大大减小了激光频率的长期漂移，将激光频率稳定在±50 MHz以内；针对激光频率的短期抖动，采用以碘分子吸收池为核心器件的稳频系统，通过半导体控温方式对碘分子吸收池精确控温，控温精度达0.03 ℃，提高了稳频精度，将激光频率进一步稳定在±8 MHz以内，满足±10 MHz以内的设计精度要求。通过搭建多普勒测风激光雷达系统，对发射激光稳频装置进行系统验证，连续4组风场观测结果表明:系统探测高度为17 km，绝大部分方差在4 m/s以下，满足测风激光雷达测量指标的要求。     

A numerical study on the combustion limits of mesoscale methane jet flames with hydrogen addition

A meso-scale jet flame model was established for the flame ports of domestic gas stoves. The influences of hydrogen addition ratio (β = 0%–25%) on the combustion limits were explored. The results show that with the increase of hydrogen addition ratio, the blow-off limit increases obviously, while the extinction limit decreases slightly, namely, the combustible range expands significantly. Quantitative analysis was carried out in terms of chemical effect and thermal effect. It was found that hydrogen addition will reduce O₂ fraction in the pre-mixture for a constant equivalence ratio. Under near-extinction limit condition, since the flame is located at the nozzle exit, the external O₂ cannot be entrained into or diffuse into the upstream of the flame, which leads to the decrease of reaction rate. However, for the near-blow-off cases, the external O₂ can be entrained and diffuse into the flame, which compensates the difference of O₂ content in the pre-mixture. Therefore, the combustion reaction is enhanced by hydrogen addition because more H radicals can be produced. In addition, as the flame is located closer to the tube with the increase of hydrogen addition ratio, heat transfer between flame and tube wall is augmented and the preheating of fresh mixture is strengthened by the inner tube wall. This heat recirculation effect becomes especially notable in low velocity cases. In conclusion, the extension of extinction limit by hydrogen addition is attributed to the thermal effect, while the increase of blow-off limit is mainly due to the intensification of chemical effect.     

Sorption kinetics in metal hydrides by leaky coating

The 3D geometry of a hydrogen absorbing metal grain (Pd) is mimicked by a membrane made of the metal with identical properties, which is sealed on one side with a hydrogen semi-impermeable surface (Cu). The hydrogen loss through the sealed membrane surface is negligible, i.e., the hydrogen uptake measurement is that of a bulk material (Sieverts measurement), but the surface desorbs sufficient hydrogen to be detected by a mass spectrometer. With this, two independent spatial and temporal kinetic properties are defined which allow the reconstruction of the time dependent hydrogen distribution inside the membrane. As proof of concept, the mechanism of hydride formation in Pd is analyzed, corroborating the formation and growth of incoherent interfaces during hydrogen sorption.     

Characteristic tryptic peptides and gelling properties of porcine skin gelatin affected by thermal action

Thermal action in extraction process had effects on characteristic tryptic peptides identification and gelling properties of porcine gelatin. SDS-PAGE, HPLC-LTQ/Orbitrap high-resolution mass spectrometry, texture analyser and rheometer were used to evaluate collagen depolymerisation degree, characteristic tryptic peptides and gelling properties of gelatins prepared in various thermal actions. Results showed that with increasing temperature and time, depolymerisation degree enlarged, while gel strength, gelling and melting temperature decreased. Mass spectra showed that 47 and 49 common characteristic tryptic peptides were identified in gelatins extracted at 50 °C and 100 °C with various times, respectively. Moreover, 34 common characteristic tryptic peptides were identified in all gelatin samples. Further comparison between this work and our previous investigations yielded 20 common characteristic tryptic peptides, which stably exist in various thermal actions. These common characteristic tryptic peptides may be very helpful for the accurate authentication of porcine gelatin.     

Structure,magnetic properties and microwave absorption properties of NdFe1-xNixO3

In this paper, a high-purity NdFe_1-xNi_xO₃ perovskite-type material was prepared by a simple sol method. At the same time, adjust the substitution content of nickel to achieve the purpose of adjusting the dielectric properties and magnetic properties. According to the respective instruments, as Ni is substituted into the NdFeO₃, the crystal microstructure will change to a certain extent, and there is a certain causal relationship between the magnetic properties and the bonding. Therefore, by adding a certain amount of nickel, the dielectric properties and magnetic properties can be adjusted to a certain balance point. NdFe_1-xNi_xO₃ material has excellent microwave absorption performance. When x = 0.2, the minimum reflection loss value is ?49.32, and the corresponding impedance matching value is 1, and the effective bandwidth is 2.2 GHz when the thickness is 5.0 mm. The material that adjusts the perovskite structure by Ni element is beneficial to make the microwave absorption peak move from high frequency to low frequency, which has a wider application range and is closer to civil, commercial, military and aerospace.     

Role of exchange coupling between the hard and soft magnetic phases on the absorption of microwaves by SrFe10Al2O19/Co0.6Zn0.4Fe2O4 nanocomposite

(1-x)SrFe₁₀Al₂O₁₉/(x)Co_0.6Zn_0.4Fe₂O₄-(SFAO/CZFO) hard/soft nanocomposite ferrite materials were synthesized by ‘one-pot’ self-propagating combustion route. The co-existence of the two magnetic phases were confirmed by XRD, FESEM, EDS and VSM. The prepared nanocomposite samples were also characterized by TGA/DSC, Raman spectroscopy and VNA. Exchange coupling between the hard and the soft magnetic grains was observed by determining the switching field distribution (SFD) curve. As a result of the competing effects of exchange interaction and dipolar interaction, magnetic parameters were observed to be sensitive to the incorporation of soft magnetic phase into the nanocomposite. Results showed that with the inclusion of soft magnetic phase, exchange coupling behaviour between the hard and the soft ferrite phases had significant influence on the microwave absorption capacity of the samples. Related electromagnetic parameters and impedance matching ratio of the nanocomposite system were discussed. A minimum reflection loss of ?42.9 dB with an absorber thickness of 2.5 mm was attained by the nanocomposite (90 wt%)SrFe₁₀Al₂O₁₉/(10 wt %)Co_0.6Zn_0.4Fe₂O₄ at a matching frequency of 11.45 GHz. This assured the candidacy of SrFe₁₀Al₂O₁₉/Co_0.6Zn_0.4Fe₂O₄ nanocomposite as a promising microwave absorption material in the X-band (8–12 GHz).     

Cheese ripening in nonconventional conditions: A multiparameter study applied to Protected Geographical Indication Canestrato di Moliterno cheese

A multiparameter study was performed to evaluate the effect of fondaco, a traditional ripening cellar without any artificial temperature and relative humidity control, on the chemical, microbiological, and sensory characteristics of Protected Geographical Indication Canestrato di Moliterno cheese. Ripening in such a nonconventional environment was associated with lower counts of lactococci, lactobacilli, and total viable bacteria, and higher presence of enterococci, in comparison with ripening in a controlled maturation room. Moreover, fondaco cheese underwent accelerated maturation, as demonstrated by faster casein degradation, greater accumulation of free AA, and higher formation of volatile organic compounds. Secondary proteolysis, as assessed by liquid chromatography-mass spectrometry of free AA and low molecular weight peptides, did not show any qualitative difference among cheeses, but fondaco samples evidenced an advanced level of peptidolysis. On the other hand, significant qualitative differences were observed in the free fatty acid profiles and in the sensory characteristics. Principal component analysis showed a clear separation of the fondaco and control cheeses, indicating that ripening in the natural room conferred unique sensory features to the product.     

Evaluation of in-situ formed La2O3–TiO2–La2O2CO3 nanocomposite photocatalyst for H2 production

The photocatalytic evolution of H₂ over La₂O₃ decorated TiO₂ catalyst was examined under solar light. It was observed that during the course of the reaction, the transformation of La₂O₃/TiO₂ into La₂O₃–TiO₂–La₂O₂CO₃ occurred and these species effectively suppressed electron-hole pair recombination by forming electron trapping centres on the surface, resulting in an increased visible light absorption and improved H₂ yield. The 2 wt%La₂O₃/TiO₂ nanocomposite demonstrated better H₂ yield (～8.76 mmol (g_cat)^?1) than the bare TiO₂ (～1.1 mmol (g_cat)^?1). The catalyst was stable even after several consecutive recycles with no substantial loss of hydrogen production rate. The H₂ rates were correlated with the physicochemical characteristics of the catalysts examined by BET–SA, H₂-TPR, XRD, UV-DRS, Raman spectroscopy, FTIR, HRTEM, EPR and PL spectroscopy.     

Optical properties and radiation stability of SiO2/ZnO composite pigment prepared by co-sintering method

Thermal control coatings (TCCs) are an essential part of the thermal control systems in the spacecraft. Solar absorptance and emittance are the key performance parameters of TCCs. To develop an ultra-low solar absorption and stable inorganic TCCs for surface radiator, different TCCs were prepared by co-sintering ZnO and SiO₂ nanoparticles to form Zn₂SiO₄/SiO₂ pigment in this work, and the optical properties and radiation stability were systematically studied. It is found that the coating based on composite pigment has high reflectivity in the ultraviolet band and excellent optical performance possessing the low solar absorption of 0.06. In addition, the Zn₂SiO₄/SiO₂ coating demonstrates the highest proton and electron radiation stability because that SiO₂ between Zn₂SiO₄ particles acts as the relaxation center of the defects caused by radiation.